Sigma DP CyberSerial Dual PCI RJ Guía de instalación descargar pdf (Pagina 3)

Hardware Installation

Note: For Low Profile systems, replace the currently

mounted bracket with the included Low Profile bracket.

General instructions for installing the card are provided

below. Since the design of computer cases and

motherboards vary, refer to your computer’s reference

manual for further information, if needed.

Static Electricity Discharge may permanently damage

your system. Discharge any static electricity build up in

your body by touching your computer case for a few

seconds. Avoid any contact with internal parts and

handle cards only by their external edges.

1. Turn OFF the power to your computer and any

other connected peripheral devices.

2. Unplug the power cord from the back of the

computer.

3. Remove your computer cover. Remove the slot

bracket from an available PCI slot.

4. Set J1 and J2 jumper settings to the desired voltage

only if your serial device needs additional power

from the serial port. However, most serial devices

do not require additional power. For more

information see Jumper Settings on page 2. The

jumpers can be removed if power is not required. If

power output is required, connect the board's power

connector.

5. Carefully align the card's bus connector with the

selected PCI slot on the motherboard. Push the

board down firmly, but gently, until it is well seated.

6. Replace the slot bracket holding screw.

7. Replace the computer cover and reconnect the power

cord.

1 2 3 4 5 6 7 8 ... 11 12

Sin comentarios

Sigma DP CyberSerial Dual PCI RJ Guía de instalación Pagina 3